Eight kinds of call make up most of a week. Here is what each one turns into once somebody is standing in front of the machine.
This is not a highlight reel. It is the actual distribution of what comes through the phone across a typical week in the West Valley, and what each of those calls turns into once somebody is standing in front of the machine.
Evaporator fan motors, defrost heaters and thermostats, dampers, control boards, sealed system diagnosis on built-in columns.
Blocked defrost drain lines, cracked drain pans, door seals that stopped sealing years ago.
Drain pumps, blocked pump filters, door lock assemblies, siphoning drain hoses.
Vent lines opened and cleared end to end, heating elements, thermal fuses, gas igniters and flame sensors.
Full descale, spray arm clearing, drain path checked including the disposal knockout plug.
Sensors, igniters, bake elements, calibration, control boards after a self-clean cycle.
High voltage side diagnosed properly on built-in and over-the-range units, waveguide covers, interlock switches.
Jams cleared, flanges resealed, units replaced when the bottom seam has gone.
Installation is a listed service on our Yelp profile, not an afterthought. Refrigerators including panel-ready columns, stacked laundry sets, dishwashers, ranges and cooktops, over-the-range microwaves, hoods, disposals, ice makers and compactors. Levelled, connected, tested, old unit disconnected properly.
A sealed system failure on a ten year old freestanding refrigerator. A countertop microwave under two hundred dollars. A disposal leaking from the bottom seam. In each of those cases the repair is technically possible and financially silly, and saying so costs us a job and keeps a customer.
Every image here is ours, taken on a real call in the Valley. There is no stock photography on this site and there never will be.









