VSH
Home / Services / Oven & Stove
Service

Oven and stove repair

Professional ranges are gas appliances first and appliances second. Igniters, valves and safety circuits get treated accordingly.

Price agreed before we start Family owned since 2015 Open 6 days, Sunday included

Won't heat, or won't hold temperature

Frigidaire electric range with an over-the-range microwave
Coil-top electric range with an over-the-range microwave above it.

Start with what an oven is supposed to do. GE Appliances says oven temperature can vary by plus 30 and minus 30 degrees Fahrenheit as the oven cycles on and off, a total swing of 60 degrees, and calls that fluctuation common. A thermometer reading 325 in an oven set to 350 can simply be catching the bottom of a cycle. GE also says that on newer models with a preheat signal, it comes at about 7 to 12 minutes, when the oven is not yet at the set temperature.

When the average really is off, the likely parts depend on the fuel. On an electric oven, the bake element and the temperature sensor are the two usual candidates, and both can be tested with a meter once the range is unplugged. On most gas ovens with a glow bar igniter, the igniter and the gas safety valve are wired in series, and the valve opens on current. An igniter can weaken with age and still glow while drawing too little current to open the valve, so the oven lights slowly or does not light at all.

For a gas oven that will not heat while the cooktop burners work, GE's homeowner check is to turn the oven on, open the door and look for a red glow at the igniter. If there is no glow, GE says there may be a malfunction with the igniter, the on/off control or other electrical components.

The full walk-through, including published preheat times and what stretches them, is in our guide on why an oven does not reach the temperature you set.

Check the door before anything else

Two of GE's free checks for an oven that loses heat: look at the oven gasket for rips or tears, which may allow heat to escape. Then look at the racks: GE says placing racks in backwards may keep the door from sealing or closing properly. Refit them the way the manual shows, then close the door and look again.

Calibration, and why to measure first

Many ovens let the owner shift the temperature offset from the control panel. GE says the temperature can be adjusted up to 35 degrees Fahrenheit hotter or cooler on controls with up and down pads. Whirlpool's adjustment can be set between 30 degrees hotter and 30 degrees cooler, and Whirlpool advises never calibrating more than 10 degrees at a time.

Neither manufacturer leads with a thermometer. GE's suggested check is a batch of canned biscuits cooked to the package directions. If they are cooked properly within the time range on the package, GE says the oven is calibrated properly. Calibration shifts the reading but leaves a failing element or sensor in place, so the part should be tested before the offset is changed.

Gas burners that click but will not light

GE says most ignition-related issues happen because the burner head gets clogged after cleaning or after spillovers, and that the burner will keep clicking and will not ignite until the ports are clear and the burner dries out. GE also says each burner head has to sit in its correct position, with the cap that matches it.

For clogged ports, Whirlpool says to use a straight pin, not a wooden toothpick, and not to enlarge or distort the port. Its cleaning guidance gives the reason: a toothpick can break off and prevent proper gas flow.

Clicking with every knob off is a different complaint. GE's first check is that the knob is turned completely to OFF and has popped back out, and GE notes that moisture after cleaning can also cause intermittent clicking. Hearing several burners click while only one lights is normal. Clicking that carries on once the cooktop is dry and every knob is off can point to a switch or the spark module, which is a repair.

Self-clean, and an oven that quits right after it

GE says the door must be locked for a self-clean cycle to run, and if it will not unlock afterward, to wait approximately 30 minutes for the oven to cool and try again. Before the cycle, GE says to remove racks other than self-clean racks, along with probes, foil, liners, cookware and pans. Loose spillover should be wiped out first, because GE says a lot of smoke during self-clean comes from excessive grease or soil inside the oven.

If an oven stops heating right after a self-clean, mention it when you call. A failed thermal fuse or control board can be the cause, and both are replaceable parts.

Glass cooktops and anti-tip brackets

A cracked glass cooktop needs service. GE says it does not recommend using the cooktop until the appliance is repaired, and on a range, does not recommend using the oven until the cooktop is fixed.

A freestanding range should be held in an anti-tip bracket. The Consumer Product Safety Commission says a range anti-tip bracket can save you or your child from serious injury or death, and asks owners to check that the bracket is attached securely to the wall or floor and that the range is held securely in it.

Where the homeowner part ends

Do not slide a gas range out to look at the connector behind it. The CPSC says moving the appliance can cause an older weakened connector to fail completely, possibly resulting in a deadly fire or explosion, and that only a qualified professional should check the connector and replace it if needed. If you smell gas, SoCalGas says to evacuate the area immediately and call from a safe location, and not to turn lights or electrical appliances on or off.

Questions we get

Do you work on professional ranges?

Yes, including Thermador, Wolf and Viking. We also service Miele, Bosch, GE, Whirlpool, Frigidaire, LG and Samsung ranges.

My burner clicks and clicks and will not light

Let the burner dry fully, make sure the cap sits on its matching burner head, and clear any clogged ports. Whirlpool says to use a straight pin and not a wooden toothpick, which can break off in the port. If it still clicks without lighting, the switch, the spark module or the electrode is the next thing to test.

My oven thermometer reads 25 degrees low. Is the oven broken?

Not necessarily. GE Appliances says oven temperature can vary by plus 30 and minus 30 degrees Fahrenheit as the oven cycles on and off, and calls that fluctuation common. Average several cycles, or use GE's canned biscuit test, before deciding the oven is off.

The price of your repair is agreed with you before any work starts.
Where we work

Book a technician

Tell us the appliance and what it is doing. The price is agreed before any work starts, and we are open Sunday.

Call nowBook